Posted by Walt Davies on August 15, 2007 at 08:45:35 from (70.41.254.229):
In Reply to: Recall Toys. posted by steve-jd4000 on August 14, 2007 at 21:21:04:
If we built everything that we buy here in the USA we would have to immigrate all of Mexico and south America to handle the overload of work. How many of you want that to happen. Think about it for minute or so. Walt
They did one so-called survey a long time ago in Chicago, the results were that Black kids had lower IQ's but white kids didn't they said it was because Black kids ate more of the lead paint. On this one study we have based all of this lead problem and have been removing it from the earth. I would still like to know why it only hurts today's kids but didn't bother any of us older people who grew up with lead in everything. My IQ's is over 130 (the two tests I took only go that high) Now if I had grown up without all that lead would I be another Einstein. By the way lead was added to gas after WW-II. All the canned food that we ate was soldered together with lead based solder. Our water pipes and sewer pipes were put together with lead. We had lead in just about everything, now its not in anything and the kids have a hard time adding 2 and 2 and we have all these kids on prozac to quiet them down in the class room. When I went to school that was done with a strap, it cheaper and worked better. sorry to rant on but I just get mad at todays way of teaching and all these things that will kill us all off. Funny the life expectancy has gone way up. Now that is based on the fact that we lead kids are getting older not those lead free young kids of today. Walt
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
