Tractor Talk Discussion Board |
Re: OT--Trailer Brakes
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Doug N on August 12, 2007 at 07:37:05 from (64.12.117.74):
In Reply to: OT--Trailer Brakes posted by David in TN on August 11, 2007 at 09:31:38:
Yes, most below are right. It's called caging the brakes. It's a special T-looking bolt. Stick the T into the center hole in the back of the pancake chamber, give it a quarter turn and try to pull it out. If it won't come out, you are locked in and can start turning the nut in. When you put it in, make sure the nut is backed all the way off to the end of the cage bolt. You will have to turn that nut d*mn near all the way to release the brakes. You can air it up, but it will take alot longer to plug fittings on one side, and make adapters to hook air line up. Doug N
Replies:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
John Deere B 1943
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|