Tractor Talk Discussion Board |
Defective new part
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by MTC on August 02, 2007 at 20:19:22 from (207.190.110.248):
Hi guys-first I want to THANK all of you for your advice on the problem of my Allis G.I could not get numbere 4 piston to work and I tried every thing.I found to night the new manifold I ordered was plugged in the exhaust port on number 4.I took it off and blew air in all the ports to make sure they were all open and sure enough number 4 was casted poured shut.I had to do some drilling and welding but I got it opened and back on the tractor and it runs like a top.The manifold was made in China or Japan.My advice guys is to check new parts out before installation.If I would have it sure would have saved me alot of grive and time.Again Thanks every one.Mike
Replies:
Home
| Forums
Today's Featured Article -
Engine Valves - Some Helpful Information - by Staff. Intake - On the intake stroke the piston moves doward, sucking in carburized fuel through the open intake valve. Exhaust valve is closed. Compression - With both the intake and exhaust valves closed, the pistons upward stroke compresses or squeezes the fuel into the combustion chamber. Firing - Ignited by the spark, the compressed fuel explodes and forces the piston downward on its power stroke. Intake and exhaust valves are closed. Exhaust valves and seats are exp
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|