Tractor Talk Discussion Board |
Re: voltage regulator VS cut out in 6 V system
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by 35 A on July 30, 2007 at 20:33:09 from (65.25.139.234):
In Reply to: voltage regulator VS cut out in 6 V system posted by flashback on July 30, 2007 at 19:55:33:
The cut out acts as a switch allowing the gen. to charge the battery, but does not control the amount of charge going to the bat. The older gen. usually had an adjustment screw on the end plate and or movable 3rd brush to control amperage flow to the bat. You could over charge the bat. if the charging rate was set too high and cause the bat. to "boil over" The voltage reg. system only allows the gen. to charge the bat. as needed. If the battery is low the reg. compensates by increasing the amp. flow to the bat. Hope this helps
Replies:
Home
| Forums
Today's Featured Article -
Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|