Tractor Talk Discussion Board |
Our baling rig- Pics
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Don-Wi on July 22, 2007 at 22:32:08 from (70.224.245.55):
I finally got a few pics of our baler while it was still hooked up and out of the shed. We run a Massey 285 on a Massey #12 baler (later model) and stack 6 high on the wagons behind it. It may be too big fir some guys, but you can also pull 2 loads in tandem behind the baler on the road and be able to get up & going, and to safely stop as well. Our 165 has plenty of power to run the baler, but it struggles to get a load of hay going on the road sometimes. Still a great tractor, but the 285 is our Baling tractor... Get some good bales outta this baler too. Square, tight, and it will take thin or thick hay and give you a uniform bale. The 2nd crop we had double raked I had to slow down to 2nd low, MP high to keep from plugging up. It still took it better than I thought. More thasn once I thought for sure it was gonna break a shear bolt but it kept plugging along, even though the pick-up couldn't jam anymore hay in it until I would stop a second for it to chew... Still plenty fast for one guy on the wagon though. Donovan from Wisconsin
Replies:
Home
| Forums
Today's Featured Article -
Engine Valves - Some Helpful Information - by Staff. Intake - On the intake stroke the piston moves doward, sucking in carburized fuel through the open intake valve. Exhaust valve is closed. Compression - With both the intake and exhaust valves closed, the pistons upward stroke compresses or squeezes the fuel into the combustion chamber. Firing - Ignited by the spark, the compressed fuel explodes and forces the piston downward on its power stroke. Intake and exhaust valves are closed. Exhaust valves and seats are exp
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|