Tractor Talk Discussion Board |
Re: gotta brag a little...
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Don-Wi on July 22, 2007 at 15:28:51 from (70.224.245.55):
In Reply to: Re: gotta brag a little... posted by rrlund on July 22, 2007 at 08:12:33:
I guess dad has 1700 bales written down of the 1st crop- we almost made 1200 of 2nd, but we also chopped a little bit the last 2 weeks as it was cut just to feed the girls something other than dry 1st crop- they were getting mad at us and the milk dropped off like a stone when the corn was gone. Got it back up considerably with some nice 2nd. We even had 2-3 less acres of 2nd to cut as well, so all in all I think if we had baled it all again, we probably would have had a good 1700 bales again. Never in my short life have i seen 2nd crop come out that nice!! Didn't mean to salt that wound, but ya gotta brag about these things... Donovan from Wisconsin
Replies:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|