Tractor Talk Discussion Board |
Gooseneck Trailer Axle Positioning
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Matt Weltz on July 21, 2007 at 07:23:24 from (167.142.225.157):
I have a 25' gooseneck trailer with 7,000lbs. axles. Alot of the loads I haul are fairly tall so I have recently added duals (kit from JC Whitney) to the trailer for more lateral stability. The trouble is that when the trailer is loaded real heavy and I hit a bump, the outer framework of the trailer hits the dual. To stop this recently, I have put a 4x4 block in between the frame and the axle so that the suspension cannot squat down under a load. The trouble is this makes all the bounce go to the tires and I am affraid will cause a blowout. Not to mention that the trailer pulls extremely rough now. So I need another fix. I am wondering why I couldn't just move the axles from the top of the leaf springs to the bottom to give me that additional 4" of clearance. I know I should just buy a bigger trailer that was built to accomodate duals and heavier loads but I just can't afford to do that at this time. Your thoughts would be appreciated. Thanks! Matt
Replies:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|