Tractor Talk Discussion Board |
Why you dont wait till last min. to get things running
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by roger roland on July 15, 2007 at 20:59:45 from (12.154.10.254):
just finished redoing a super C slow progess i thought paid off when hooked up battery... finally done , pulled switch & it cranked over, so far so good..... then the problems start oil comeing outta oil filter gasket( easy fix tighten oil filter screw some more) hummmmm wheres that anti-freeze comeing from , great gotta pull radiator to fix where i didnt see, Just glad i didnt have tractor parade tomorrow... just goes to say dont wait till you need something you might have small kinks to work out.... & hey georgeky thanks for all your help over last few months putting this together
Replies:
Home
| Forums
Today's Featured Article -
The Tractor Parade: Story of a Case SC - by Bernie DeLon. On a early fall morning back in 1994, I opened the newspaper and happened to spy an article about a local antique tractor club having their annual show that weekend.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|