Tractor Talk Discussion Board |
Re: help on simms 6cly injection pump.
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by RodInNS on July 11, 2007 at 19:30:06 from (24.224.246.156):
In Reply to: help on simms 6cly injection pump. posted by FORD9000PULLER on July 10, 2007 at 23:35:39:
Idle and high idle are set by adjusting the throttle lever stop screws on the side of the pump. Max delivery is adjusted by turning the slotted head screw in front of No 1. delivery valve, near the cam box filler plug.... Fuel up, screw out (counter to the clock). If you're picky about it, and like to know how far you've gone, then I think that pump has a cap on the back end where the rack goes in....(the minimec pumps do anyway) If you like you can measure rack travel with a dial so that you know where it's set, and then put it back exactly later on if you like. I do that since I don't have a dyno. Just zero the dial when the rack is fully retracted (shutoff out), and then take your readings at full extension. Do it a couple time to double check and make sure the govenor is giving full travel.... Rod
Replies:
Home
| Forums
Today's Featured Article -
Engine Valves - Some Helpful Information - by Staff. Intake - On the intake stroke the piston moves doward, sucking in carburized fuel through the open intake valve. Exhaust valve is closed. Compression - With both the intake and exhaust valves closed, the pistons upward stroke compresses or squeezes the fuel into the combustion chamber. Firing - Ignited by the spark, the compressed fuel explodes and forces the piston downward on its power stroke. Intake and exhaust valves are closed. Exhaust valves and seats are exp
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|