Re: Stopping a leak from a gas tank. (Any Ideas other than r
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by MBU on July 09, 2007 at 10:27:43 from (68.176.130.222):
In Reply to: Stopping a leak from a gas tank. (Any Ideas other than repla posted by jd720spec on July 09, 2007 at 09:37:00:
jd720spec,
They do make some two part epoxy that may work if the tank was drained and then applied, but on a tractor, the vibrations usually break it in a very short time.
If the tank has a pin hole than a sheet metal screw with a rubber washer will work but if it's a crack or a seam, then have it soldered by a professional company that is equipped to do this kind of work.
Good luck and please post back as to what you eventually do to stop the leak.
Replies:
Home
| Forums
Today's Featured Article -
Engine Valves - Some Helpful Information - by Staff. Intake - On the intake stroke the piston moves doward, sucking in carburized fuel through the open intake valve. Exhaust valve is closed. Compression - With both the intake and exhaust valves closed, the pistons upward stroke compresses or squeezes the fuel into the combustion chamber. Firing - Ignited by the spark, the compressed fuel explodes and forces the piston downward on its power stroke. Intake and exhaust valves are closed. Exhaust valves and seats are exp
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|