Tractor Talk Discussion Board |
Re: Hydraulic Motors
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Mathias NY on July 05, 2007 at 04:36:05 from (12.4.26.248):
In Reply to: Hydraulic Motors posted by Wardner on July 04, 2007 at 19:15:29:
Well, I don't have a problem with it, but I can't speak for everyone. It should work fine. You could also try plumbing the motors in parallel and putting a oneway check-valve in one line for each motor to prevent them from spinning in the wrong direction. This way they could both dump back through the spool valve and still only run in one direction. Your way is probably less complicated...
Replies:
Home
| Forums
Today's Featured Article -
The Tractor Parade: Story of a Case SC - by Bernie DeLon. On a early fall morning back in 1994, I opened the newspaper and happened to spy an article about a local antique tractor club having their annual show that weekend.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|