Tractor Talk Discussion Board |
Just when things where going good.
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Wisconsin Cowman on July 02, 2007 at 18:03:56 from (70.106.183.253):
Over the last weekend I went to the local tractor pull. Have not pulled in years since I was 15. I decide to pull because there was only one tractor that was in the class. I decide I take my Oliver 1955. Hooked up to the sled going good not to fast. Got closer to the end Had a full pull lost traction till all of a sudden with out warning a rod decide it needed some fresh air and went right through the oil pan. I was hoping I win the class and get the prize money and I did. Some of the prize money will help to rebuild the bottom half of the engine. Did the top half last year during winter.
Replies:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|