Tractor Talk Discussion Board |
Chevy 355 Value
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Matt Weltz on June 25, 2007 at 16:29:31 from (167.142.225.158):
This past year in high school, my senior year, I rebuild a chevy 350. It is a 2-bolt main 350 block out of a '71 chevelle. Block was bored .030" over and boiled. Heads were boiled and rebuilt with all new valves, valve seats, valve guides, and valve springs. Here is a list of the new parts: Fel-Pro gasket set, Federal Mogul Speed-Pro cam (.420 & .443 lift), Accel Performance plug wire set (8mm), GM aluminum intake manifold, Auto-Lite spark plugs, Diamond-turned Badger Pistons (minimum bore 4.0300), Federal Mogul Sealed Power piston rings, lifters, pushrods, cam-rod-main bearings, Edelbrock Perfomer-Link True Roller timing chain set, Expand-Tite expansion plug set, vaccuum port plug, thermostat, chrome oil dipstick-valve covers-air filter. Computer dyno shows 350 horsepower and 425 ft. lbs. of torque. Wondering what it would be worth??? I was thinking around $1,500 but am not sure. Thank you!!!
Replies:
Home
| Forums
Today's Featured Article -
The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|