Tractor Talk Discussion Board |
Re: Converting from Crop to Wide wheel Front End
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by MarkB_MI on May 29, 2007 at 03:30:13 from (216.234.98.95):
In Reply to: Re: Converting from Crop to Wide wheel Front End posted by ford4roy on May 28, 2007 at 19:48:47:
Roy, By ballast, I meant to pump liquid ballast (calcium chloride and water) into the tires. The advantage of liquid ballast is that it is lower in the tire and will lower the CG even more than weights. You can add ballast (or wheel weights) to the front tires as well. Your wheel weights are a good start. Of course extra weight will make your tractor sink even faster in soft ground. Really, the best solution is to stay away from uncertain ground. I nearly stuck my 4000 in a pond doing exactly what you did. I'm not aware of a roll bar available for the hundred series tractors.
Replies:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|