Tractor Talk Discussion Board |
Re: OT Troy Built Tomahawk chipper
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by TomCNY on May 12, 2007 at 18:51:24 from (24.58.221.198):
In Reply to: OT Troy Built Tomahawk chipper posted by Dave H (MI) on May 12, 2007 at 12:30:24:
Lots of variables here, Dave. I have a Tomahawk that I bought used, but like new, for $375 ten years ago. I think new ones of that size (12 or 13 hp) sold for about $700 at that time. It does a good job chipping and shredding if I don't push it too fast and if I don't try to feed it a branch bigger than about 2 1/2 inches in diameter. My main complaint is that the discharge opening is so close to the ground that I have to keep an eye on it or I am frequestly clogging it up! Then I have to shut things down and clear it out again. When chipping the bigger material, it doesn't seem to take long to pile enough in front of the discharge to cause the clogging to start. In short, it all depends on the condition of the Tomahawk, the amount and size of the material you want to chip, and what you think the value of your services might be! Good luck regardless of your decision. Tom
Replies:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|