Tractor Talk Discussion Board |
Re: mathmatician needed
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by mark on May 03, 2007 at 18:19:55 from (172.163.243.106):
In Reply to: Re: mathmatician needed posted by midwest redneck on May 03, 2007 at 14:10:33:
Thanks to everybody who responded. First, being from Kentucky, we weren't taught such mathematics in the 5th grade. And besides that, it has been many years since I eventually was taught the theory of pi. Therefore when challenged, I am not too proud to publicly admit my ignorance and seek the help of those more learned, than I. As for the environment and lead......lead is a naturally occurring mineral within the upper strata of the Earth's crust. I would guess it has been present for at least a few billion years, if not longer. It is actually a rather innocuous substance unless heated to the point of vaporization (900+ degrees F) or rendered into dust and then inhaled. Obviously, iron/steel wheel weights are superior structurally and if money wasn't an issue for me, I'd just lay out about $500 for a thousand pounds of used rear weights and be done with it. Concerning how the weights would be formed/molded, yes, they would be poured about one inch thick and stacked. My tractor has flanged axles, so no center hole is needed. The weights would just have to be removed in order to unbolt the wheel in case of a flat tire, etc. Thanks again.
Replies:
Home
| Forums
Today's Featured Article -
Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|