Tractor Talk Discussion Board |
AC 6140 PTO question
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by gcpd35 on April 29, 2007 at 10:05:57 from (24.240.200.90):
Hi, I'm a new tractor owner and have already posted a question about brush hogs under the implement section. Anyway here is my question. I have a AC 6140, it has two levers under the left side of the seat (one on the fender wall and the other on the frame/floor) The lever on the fender wall says PTO on or off. The one on the floor, I believe is what engages the PTO. The lever on the fender wall has to be pulled up to pull the other lever up, but then there is a God awfull grinding noise. What am I doing wrong? To engage the PTO right now, I have been shutting the tractor off, and pulling the levers up, and then starting the tractor with the PTO on. That can't be good. I hope I don't sound like to big of an idiot, but I figured that there was someone here who would be able to help me. Seems like there are a lot of knowledgable folks on here. Thanks!
Replies:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|