Tractor Talk Discussion Board |
Re: (OT) 87 F-250 6.9 Diesel hydraulic operated c
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Jim K on April 28, 2007 at 18:52:13 from (207.69.138.134):
In Reply to: (OT) 87 F-250 6.9 Diesel hydraulic operated clutc posted by RMinVA on April 28, 2007 at 17:28:15:
Those things can be a pain in the a$$ to bleed. Did you let the master go dry when you changed the slave. And if so did you bleed the master again. Usually I'll let it set overnight and let the air bubbles and foam rise up to the master rather than try to force air downward. give the clutch pedal a few pumps once in a while. You should see the pressure plate seperate from the disk at least a 1/6" when pushing the clutch pedal down if all the air is out of the system.
Replies:
Home
| Forums
Today's Featured Article -
Restoration Story: 1951 Farmall H - by The Red (John Fritz). I have been a collector of Farmall tractors since 1990 when I first obtained part of the family farm in Eastern Indiana. My current collection includes a 1938 F20, 1945 H, 1946 H, and the recently purchased 1951 H. This article will focus on what I encountered and what I did to bring the 1951 NEAR DEATH Farmall H back to life.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|