Tractor Talk Discussion Board |
Re: Ford 7710 Loader any good?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by David in Wales on April 25, 2007 at 03:13:22 from (86.146.7.90):
In Reply to: Ford 7710 Loader any good? posted by fixer007 on April 25, 2007 at 03:01:03:
Hi; Nice tractor, you sit up high with flat floor cab giving good vision. Obviously check out steering and front axle wear if its done a lot of loader work. Ford had Major problem at this time with porous engine blocks. Most will have been replaced with improved block which has X shaped raised castings on side of block. If it has the "bubble cab" look Very carefull for rust, in England they are rusting out and a real problem. Even if not showing rusty patches on the flat panels and on the bottom of the doors, lift up rubber seals around windows and door glasses, thats where the rust starts from the inside eating out. Apart from these faults, they are basically a good tractor, obviously check for previous owner abuse & neglect or care. Same as any tractor you look at buying. Hope you have good luck, post a photo if you get it. Cheers David
Replies:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|