Tractor Talk Discussion Board |
PHOTO - the opening furrows
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by David in Wales on April 20, 2007 at 23:41:15 from (86.142.187.162):
HI Gang; This shows the opening furrows. So this guy has gone up the plot turning a very shallow single furrow using only the rear mouldboard. Then back down the otherside again a very shallow single furrow. This leaves the open furrow, the split. The next run he uses both mouldboard to plough back those shallow furrows towards the centre split at normal depth. This turns back those first 2 furrows and sandwiches the grass underneath. So all the grass roots have been cut off and stops any grass growing. These opening 2 furrows are slightly higher than the rest of the furrows. We call this the "cop" and the last open furrows the "rean". Dont know where these names originated. Another term used here to travel accross the field and then back down on the next row is a "bout". Hope you can understand my descriptions from the photos. Cheers David
Replies:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|