Tractor Talk Discussion Board |
Re: New 3 point arm end
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Janicholson on April 17, 2007 at 18:43:22 from (66.173.50.60):
In Reply to: New 3 point arm end posted by cj3b_jeep on April 17, 2007 at 07:41:32:
I've built/rebuilt several, Either way the preparation for the weld must be very well done. The arm should be taken off (for flat weld position) and the old socket removed after marking for the needed cut. The cut should then be ground to match the new component. I like the socket/ball better than the one with a piece of arm, for the reason that the bending moment (sorry for the high fallooten term) applied to the location of the weld will be far less when the weld is closer to the ball hole. This doesn't mean a poor weld is OK, it just means the weld will be under less stress. It will also be better looking. Groove the weld point to about 1/3 material thickness, make short passes (1"), and let it cool for three or more minutes between passes. Go for it. (I like E-7014) JimN
Replies:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|