Tractor Talk Discussion Board |
Re: Ford 841 work with a case 6000 3 bottom Plow?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by JWCinMS on April 11, 2007 at 15:57:14 from (199.133.90.83):
In Reply to: Re: Ford 841 work with a case 6000 3 bottom Plow? posted by 30 pointer on April 11, 2007 at 07:43:10:
I just got back to the forum and the question was answered in a later post. If you take the back bottom off you will need to move the longer landslide or furrow wheel on the back of the rear bottom up to the second plow. Most plows have a long bar or beveled wheel on the rear bottom. Most of the modern Ford plows (mid 50s and later) had the wheel which helped cut down on the drag by a small amount. You will likely need to remove the vertical portion of the frame for the last bottom if you are going to plow very deep because it will be traveling over the ground that has not been plowed yet.
Replies:
Home
| Forums
Today's Featured Article -
Talk of the Town: The Saga of Grandpa's Tractor - by The following saga is from the Tractor Talk Discussion Forum. Someone. The saga starts with the following message: Hey guys I have a decision to make. I know what you all will probably suggest and it will probably agree with me way down inside, but here it is. I have a picture blown up and framed in my "tractor room" of a Farmall M. It was my Grandpa's tractor, of which whom I never got to meet. He froze to death getting this tractor out of the barn to pull a truck out of the ditch before I was born. Anyway my dad and aunt had to sell it at the auction,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|