Tractor Talk Discussion Board |
siezed engine, break towing in gear?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Donovan on April 08, 2007 at 15:00:26 from (207.172.177.67):
I'm trying to get my fathers old Ford 860 running and found out the engine is siezed. A sparkplug hole was open for many years, so i am assuming a piston is rusted, so i want to spray PB breaker down all the sparkplug holes, and then i wnated to try to tow it while in gear. My question if i am towing it backwords, can i only use reverse? I heard that using a higher gear like 5th might be eaiser to break it in. Also should i just tow it while in gear, or push down the clutch, wait for it to start to turn, then let up on it, like compression starting a car. If there is any other easy ways of breaking an engine please share.
Replies:
- Re: siezed engine, break towing in gear? Kelly C 09:00:24 04/09/07
(0)
- Re: siezed engine, break towing in gear? oldcraneguy 07:31:38 04/09/07
(0)
- Re: siezed engine, break towing in gear? billyar 04:02:37 04/09/07
(0)
- Re: siezed engine, break towing in gear? hay 03:38:33 04/09/07
(0)
- Re: siezed engine, break towing in gear? Paul from MI 19:17:04 04/08/07
(0)
- Re: siezed engine, break towing in gear? Jim Johnson 18:00:39 04/08/07
(2)
- Re: siezed engine, break towing in gear? Mike in Ind 16:59:57 04/08/07
(0)
- Re: siezed engine, break towing in gear? JK-NY 16:43:08 04/08/07
(0)
- Re: siezed engine, break towing in gear? georgeky 16:00:53 04/08/07
(0)
- Re: siezed engine, break towing in gear? old 15:26:35 04/08/07
(0)
- Re: siezed engine, break towing in gear? kito169 15:11:14 04/08/07
(1)
Home
| Forums
Today's Featured Article -
Field Modifications (Sins of the Farmer) - by Staff. Picture a new Chevrolet driving down the street without it's grill, right fender and trunk lid. Imagine a crude hole made in the hood to accommodate a new taller air cleaner, the fender wells cut away to make way for larger tires, and half of a sliding glass door used to replace the windshield. Top that off with an old set of '36 Ford headlight shells bolted to the hood. Pretty unlikely for a car... but for a tractor, this is pretty normal. It seems that more often than not they a
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|