Tractor Talk Discussion Board |
Re: O/T J B Weld
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by UncleTom on April 08, 2007 at 13:14:35 from (12.218.55.83):
In Reply to: O/T J B Weld posted by Turke Bros. Farms on April 08, 2007 at 08:10:16:
I used it to hold a spark plug in the kids honda 70 when they were little. They stripped the plug.I cleaned the plug and the head with brake cleaner then smeared jb in the hole and then on the plug threads and pushed it in. Then i built it up around the plug. I had another head but they wanted to ride and i was going to change the head later. I didnt think it would last long due to the hot cold cycles. That plug never did come out in the 3 years they rode it. I havent had much success with it on plastic. Although the 15 minute seemed to work better on plastic for me. I hear the 24 hour stuff can take more heat.
Replies:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
John Deere B 1943
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|