Tractor Talk Discussion Board |
Re: Trailer Winch Size Recommendation
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by HENRY E NC on April 08, 2007 at 13:01:08 from (216.119.7.66):
In Reply to: Re: Trailer Winch Size Recommendation posted by in-too-deep on April 08, 2007 at 11:28:49:
Harbor Freight is an offshore retailer and most of their stuff is ffrom china and is dependable. I amu using a 3000 # from there with a snatch block (makes it 6000 # maximum and have nnot had a problems loading rolling stock on my trailer. I load a M amd an A Farmall with the winch I would suggest a 5000 # winch with a snatch block for heavy pulls. That should get you out of the mud. Some guys go way overboard or pull bigger stuff.
Replies:
Home
| Forums
Today's Featured Article -
Restoration Story: 1951 Farmall H - by The Red (John Fritz). I have been a collector of Farmall tractors since 1990 when I first obtained part of the family farm in Eastern Indiana. My current collection includes a 1938 F20, 1945 H, 1946 H, and the recently purchased 1951 H. This article will focus on what I encountered and what I did to bring the 1951 NEAR DEATH Farmall H back to life.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|