Tractor Talk Discussion Board |
Re: 4430 three point lift problems
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by TimS in Mo on April 03, 2007 at 16:43:25 from (66.64.248.164):
In Reply to: 4430 three point lift problems posted by 99pittsburgh on April 03, 2007 at 16:04:42:
This is a shot in the dark, but if it's cable operated between the lever and the rockshaft valve itself, one end of the cable could have slipped out of its clamp or it could need adjustment due to cable stretching or wear at the attachment points of the cable.... I know the same happened on my 4010 before, the rockshaft end of the cable had slid about a half inch from where it was supposed to be and I couldn't get full lift from the 3ph until I put it back where it started and tightened it down.
Replies:
Home
| Forums
Today's Featured Article -
The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|