Tractor Talk Discussion Board |
Re: PTO/RPM
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by old on April 01, 2007 at 09:39:15 from (4.244.90.173):
In Reply to: Re: PTO/RPM posted by oldcraneguy on April 01, 2007 at 09:23:05:
It that hog was used with an 8N then it was made to be run with a 540 PTO and if your running it on a 1000PTO your looking for big trouble. Slow it down or you may end up haveing a blade go fling which will not be good. Those blade can and do brake some times and if your does and its spinning twice as fast as it should and it hits some thing or some one that would be bad news. I once had a blade brake on my hog and we never did find the part that broke. So what I'm saying is STOP useing the 1000 RPM PTO on that brush hog before you or some one else gets hurt
Replies:
Home
| Forums
Today's Featured Article -
Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|