|
Tractor Talk Discussion Board |
wild idea with an F20 rod brng
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by fixerupper on March 30, 2007 at 19:12:45 from (206.72.37.202):
This is just a wild idea that's a little, well maybe a lot on the far side. I pulled the rod caps on an F20 I'm slowly taking apart and the babbit (sic) has come loose and spun in one of the rods. The cap only has a couple of small scratches in it and the outside of the babbit looks OK so here's the wild idea; can I epoxy the babbit back in and make it hold? I pulled the caps last night and that's as far as I got, so it's still sitting there with the babbit stuck to the crank and the pistons are still stuck. It will be a long time before this thing runs again so I do have time to find another rod, but I just thought I would run this by you guys to see what you thought. Jim
Replies:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
