Tractor Talk Discussion Board |
Re: M vs Ford 9N
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by John A. on March 30, 2007 at 04:34:50 from (65.150.16.50):
In Reply to: M vs Ford 9N posted by earl zingraf on March 29, 2007 at 20:36:03:
earl, No need for the little Ford, personaally not my favorite. I will also say stay off the tank dam, B U T, If you are bent on mowing it. Start at the top where most tank dams have an access road, make straight runs 90 degrees opposed to the road. Going down ONLY! Never make angled runs, or runs that go longwise to the dam. Go slow! Reset your rear wheels as wide as possible to improve stability, add wts it you like. Use the principal of 90 degrees opposed to the slope and only make top-to-bottom runs, it will take longer but safty is paramount here. Little fords can and do turn over too. So just being low to the ground doesn't mean it is always right. So just use good common sence and you should make out ok. But I still agree with Allan and the other, Go get a cheap Pony or couple or 3 goats and let them do it for you. Be SAFE! Later, John A.
Replies:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
John Deere B 1943
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|