Tractor Talk Discussion Board |
Re: Firing Issues
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Buzzman72 on March 28, 2007 at 10:19:56 from (4.89.130.62):
In Reply to: Firing Issues posted by Christos on March 28, 2007 at 09:36:22:
Points must open and close, and maintain the proper gap when open. [I'm guessing you didn't check the point gap after filing the points.] The condenser is basically an electrical storage device. If the condenser isn't storing electricity ["charging"] or releasing electricity ["discharging"] properly, it must be replaced, as there is no repair procedure. There is no "armature" in the distributor. I'd suggest replacing the points and condenser--mainly because they're relatively cheap--and then setting the point gap correctly, making sure you lube the distriburot cam with some silicone dielectric grease [usually comes with the point set, sometimes liiks like a pill or a "bean."]. THEN try it again and see what you do or don't have.
Replies:
Home
| Forums
Today's Featured Article -
Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|