Tractor Talk Discussion Board |
9n woes!
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Turke Bros. Farms on March 23, 2007 at 17:28:02 from (64.12.116.141):
Man its been a while since I worked on one of these. I almost forgot how difficult a front distributor can be. Cant see, dropping the screws. Just all around bad, and on top of it..lets put a belt next to it. Have to take the hood completly off to work on it.I never owned one, or ran one of these...but my word I would rather own a Ferguson To-20 or 30 than one of these. Seems like the mass production was on the mind vs. ability to work on them. Now that im older it seems they are more automotiveIZED than most tractors. Meaning shares alot of automotive engineering than other tractors. Well the Man did make the assembly line. And im not knocking it I just think its different. And lets keep this between us and not with those guys on the 8n-9n board. DTURKE
Replies:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|