Tractor Talk Discussion Board |
Re: Adding Rear Remotes
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Tweeter on March 16, 2007 at 17:58:35 from (72.9.20.43):
In Reply to: Re: Adding Rear Remotes posted by PaulW_NJ on March 16, 2007 at 17:38:05:
The backhoe is a Bradco 11HD, which requires 9 to 14 GPM. My tractor has a hydraulic pump (gear type) mounted on the front of the motor with a shaft that produces 26 GPM at 2200 RPM. I am told by my dealer that the top cover under the seat has a plate that I can tap into for rear remotes. They say that this will also produce 26 GPM flow. They said that I need to tap into that for the pressure side and run a return line back to some port that dumps into the tranny housing. My question there is: Are the loader hydraulics supplied from the fluid in the tranny or from the reservoir in the nose of the tractor near the radiator? How can the top cover rear remotes have a 26 GPM flow then?
Replies:
Home
| Forums
Today's Featured Article -
Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|