Tractor Talk Discussion Board |
Re: snowblower for 3pth
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Rod in Smiths Falls, ON on March 12, 2007 at 05:29:56 from (209.71.222.52):
In Reply to: snowblower for 3pth posted by jaybird-oh on March 11, 2007 at 17:12:37:
I have used a 60" two stage, single auger on a tractor 66" wide and 37 hp. for the last three years. Only this month did I run into drifts where the extra width of the tractor posed a problem, requiring repeated cuts at the snow from a slight angle. On the other hand the smaller implement proved a good match for the tractor's power band in very heavy cutting in one two-hour session. The rear tire chains helped break up the hard snow in the tall drifts to make it easier to blow.
Replies:
Home
| Forums
Today's Featured Article -
Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|