Tractor Talk Discussion Board |
Re: ford 5000
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by ErnieDD on March 10, 2007 at 18:43:59 from (66.67.3.42):
In Reply to: ford 5000 posted by jody hughes on March 10, 2007 at 18:16:50:
Our early model 8 spd had a plug on the side of the transmission,by the step plate on the left, fill to overflow. Same with the rear end. You do wish to use the right stuff, the brakes are wet. Be sure to service the injector pump, it has its own sump and lube, change it out with the engine oil. Visit your dealer and get the right oil, or get oil that you know meets the ford spec. Memory is hazy, but I think you got another compartment for hydraulic too, that may be the one for the dipstick.
Replies:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
John Deere B 1943
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|