Tractor Talk Discussion Board |
Re: Perkins 6.354 engine
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Kevin (FL) on February 24, 2007 at 09:04:40 from (70.149.247.137):
In Reply to: Re: Perkins 6.354 engine posted by Rainer on February 23, 2007 at 22:21:20:
Rainer, The pop-off pressure is easily increased by tightening the spring tension. Remove the "cap" on top of the injector to access the spring nut. Also--make sure the injectors are showing a good pattern for atomization of the fuel. I would also verify the pop-off pressure before I set them. This affects injector timing and will affect proper running of the engine. (Too low a pressure, earlier "firing", too high a pressure, late firing. I was thinking the pressure on those was 2600-2800. I'll check to see if I have it in the manual.
Replies:
Home
| Forums
Today's Featured Article -
Engine Valves - Some Helpful Information - by Staff. Intake - On the intake stroke the piston moves doward, sucking in carburized fuel through the open intake valve. Exhaust valve is closed. Compression - With both the intake and exhaust valves closed, the pistons upward stroke compresses or squeezes the fuel into the combustion chamber. Firing - Ignited by the spark, the compressed fuel explodes and forces the piston downward on its power stroke. Intake and exhaust valves are closed. Exhaust valves and seats are exp
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|