Tractor Talk Discussion Board |
Re: 5.9 Cummins Oil Pressure
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by NC Wayne on February 15, 2007 at 16:33:32 from (205.188.117.14):
In Reply to: 5.9 Cummins Oil Pressure posted by Mike Tessman on February 15, 2007 at 15:30:51:
I had a brand new 4 cylinder B series, bought straight from Cummins, that never ran over 50psi cold. When hot, at an idle (1250 RPM in this application, an air compressor unit), it maintained around 10. It ran for several years like before my customer traded in the machine the unit sat on for a newer model. I routinely deal with the guys that now have it and they've never said anything about any problems with it in the time they've had it. If yours is showing zero though I'd first check the guage and make sure it's not lying, then if it's not you might try running a little heavier weight oil and see if that makes a difference, and go from there based on those two things.
Replies:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|