Tractor Talk Discussion Board |
Re: Has any body
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by jmixigo on February 15, 2007 at 16:10:50 from (69.1.13.241):
In Reply to: Has any body posted by Raleigh boulware on February 15, 2007 at 11:40:09:
I have used one quite a lot. Tough, rugged, bullet proof-naw its more than that. What you can cut with one is near any thing and they just keep on surviving horrendous abuse. The operator usually backs off before one breaks. The next weakest link is the tractor; beating on 8" trees is hard on drive lines. A Brown used to it's potential will quickly wear out a couple of tractors. BE SURE TO USE AN OPERATOR PROTECTER SHIELD. These are made of heavy mesh steel and fit across the rear of the tractor. I've had em throw 10" rocks at me HARD. With out that shield a feller could get very seriously killed.
Replies:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
John Deere B 1943
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|