Tractor Talk Discussion Board |
4020 update
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Raleigh boulware on February 15, 2007 at 06:55:57 from (192.133.192.1):
OK I bought yet ANOTHER bushhog last night for $725.00. I had one I bought a year ago wich was a Bush Hog brand 406, this one is a Bush Hog brand 307.I for the first time hooked it up to the hitch thingy and drove it around. Now the 406 I have was on there first but I could not get the PTO shaft to fit it was too long. So I set that one aside and tried this other one I bought last night. The PTO did fit this time. So I cranked to the tractor up sat there for a moment and pull the BIg lever for the PTO......and BANG!!! RIP!! Rattel and ROLL, after a few seconds the cutter was spining with hardly any noise. So I decided to take it for a spin to see what it would cut. First off it seems as if the hitch either does one thing or the other. It is either all the way up or all the way down. I can't seem to keep it in the middle. How do I set the hitch up to where the hitch will stay about a quarter the way up.
When I was cutting I barley had the motor running faster than idle. Maybe around 900 RPMS, but the cutter was cutting very clean it seemed. Is it OK to run it this slow or does it really have to run at 1900 rpms? I will go back up there with the tractor this Friday and stay the weekend again and hopefully take pictures this time!!
Replies:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|