Tractor Talk Discussion Board |
Re: farmall 656
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Janicholson on February 01, 2007 at 17:51:01 from (66.173.50.61):
In Reply to: farmall 656 posted by tyler24476 on February 01, 2007 at 16:45:30:
ejr is correct. If your drive line is completely covered with shields, it may be hard to see the system slow down. Taking a shield off for analysis is OK if you are cautious. Use the machine while looking at the shaft. If it slows, the PTO clutch is either toast, or badly out of adjustment. If you decide to repair it a book, and careful attention to process is needed. If the shaft does not slow down, the slip clutch on the mower may be at fault. Some are adjustable, some are toast when they slip under normal loads. Stripped gears in the drive are usually very noisy and obvious. If the mower blade hubs are belt driven, The belt could be slipping. Look for an adjuster or movable idler to retension the belt. JimN
Replies:
Home
| Forums
Today's Featured Article -
Field Modifications (Sins of the Farmer) - by Staff. Picture a new Chevrolet driving down the street without it's grill, right fender and trunk lid. Imagine a crude hole made in the hood to accommodate a new taller air cleaner, the fender wells cut away to make way for larger tires, and half of a sliding glass door used to replace the windshield. Top that off with an old set of '36 Ford headlight shells bolted to the hood. Pretty unlikely for a car... but for a tractor, this is pretty normal. It seems that more often than not they a
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|