Tractor Talk Discussion Board |
Re: Forklift mast for 3 pt.
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by NE IA Dave on January 28, 2007 at 10:01:51 from (12.206.8.41):
In Reply to: Forklift mast for 3 pt. posted by Joel from IA on January 27, 2007 at 13:51:23:
I have been around a few of these and they are for the most part very good at a very reasonable price. A mistake made by a farmer who was helping us one day was the 3 point settled down on him when he had lifted alot of plywood to the roof for us. It was a little side hill, but we were getting away with some pretty large lifts. Anyway while the mast was very high I jumped on to skid some plywood off. The 3 piont being partly up made a hinge point on the 3 piont lift arms. You know there is no solid lift arm at this position, nor down pressure, so the up hill arm came up enough to make it tip extreemly downhill. It tipped against another lean to roof and stopped it from tipping over. Was just one of those dumb things that happen. NE IA Dave
Replies:
Home
| Forums
Today's Featured Article -
The Tractor Parade: Story of a Case SC - by Bernie DeLon. On a early fall morning back in 1994, I opened the newspaper and happened to spy an article about a local antique tractor club having their annual show that weekend.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|