Tractor Talk Discussion Board |
NC wayne
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by JoeBob/IN on January 24, 2007 at 13:25:13 from (216.241.134.48):
I looked for the serial number but all I found was a milled flat blank spot about 1"x3"... but there were some numbers upside down on the block. There were several sets there and they were all raised numbers. Didn't seem to me they were the serial numbers but I could be wrong. When I adjusted the racks it was both sides since I had the injectors out of both sides and swapped them over. It still won't fire on the left bank at first idle, you have to rev it for it to fire on that side and you can tell when at least one kicks in cause the rpms jump and she smooths out some. Right side will burn clean but left side blows a ton of raw fuel out the stack. Is it possible there is a blown gasket on that side? Seems odd that only that side would be low on compression.
Replies:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|