Tractor Talk Discussion Board |
Re: Question for Allan on 66 series
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by old fashioned farmer on January 14, 2007 at 19:16:17 from (4.225.93.239):
In Reply to: Re: Question for Allan on 66 series posted by JOE ZIP on January 14, 2007 at 13:54:05:
Ha ha. I know what you're saying but don't worry. That was a very quick fix to free up the big wood blocks that were holding it. I needed those plus the engine hoist back when I was replacing the rear tires on my JD R. It didn't have to sit like that long. God bless. --old fashioned farmer p.s. I don't like to use blocks either. If you can drop it on the floor and watch pieces fly then it doesn't need to be holding up a piece of equipment weighing almost a ton.
Replies:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|