Tractor Talk Discussion Board |
LE-Oils, No Tools
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Jim Johnson on December 20, 2006 at 19:43:44 from (67.72.98.47):
I read the literature and testimonials that they sent. I can't seem to find anything that convinces me. They talk about trucks with 650,000 and 920,000 on them and that isn't anything to brag about. I had 2,000,000 on my last truck and have about 800,000 on the one I have now. I overhauled the old one once and haven't touched this one yet. I used Rotella in the old truck and switched to Delvac in this one because I haul it. They say you can go 60,000 on an oil change but I think my conscious wouldn't let me do that. And as far as the talk about not needing to grind the crank, we didn't have to. There price comparison was @ 4.50 and 11.30 a gallon and it's a lot higher now I'm sure but in the comparison they didn't allow for the gallon of oil you use in three filter changes. My .02cts. worth. Jim
Replies:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|