Tractor Talk Discussion Board |
stud valve lever assembly famall c 1948
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Mickey Arnold on December 20, 2006 at 15:32:37 from (68.59.243.18):
I am re-assembling the engine on a 1948 Farmall C. It was dis-assembled when I bought it. I am missing one stud that goes from the head up thru the valve lever shaft end bracket. The stud has threads on both ends. The end that goes in the head is a coarser thread than the other end. The part number for the stud is 45 574 D. The valve lever end bracket is part # 42 099 DA. I was also missing the nut that goes on the valve lever center bracket. A replacement nut fits the short stud at the valve lever center bracket, and also fits the original stud that is for the valve lever shaft end bracket. Here's my problem. The replacement bolts I was going to use for the valve lever shaft end bracket don't screw into the head. I was going to use bolts of the correct length until I could get replacement studs for the original one I'm missing. I'm wondering if the head is tapped to an odd size for these studs. Can anybody help?
Replies:
Home
| Forums
Today's Featured Article -
History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|