Tractor Talk Discussion Board |
Slip Clutch for bush hog - Are they rebuildable?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Joe Stewart on December 12, 2006 at 16:28:10 from (4.231.56.48):
I'm pulling a 6 foot Woods rotary cutter behind a John Deere 2010. The slip clutch that is an integral part of the drive shaft began to slip recently. I examined it and found that one (out of two) of the discs had crumbled into pieces. I removed the six nuts and springs and pressed out the bolts. This exposed the crumbled disc, but the remaining disc is sandwiched between two pieces of steel that I cannot separate (althouh I can rotate them independently of one another - they appear to be machined together in some fashion that is not apparent by examination). Is it standard practice to simply replace the entire slip clutch or can these things be rebuilt by replacing the clutch discs? I saw some at Tractor Supply for about $120, but I thought it might be economical to rebuild. Thanks for input. Joe Stewart
Replies:
Home
| Forums
Today's Featured Article -
History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|