Tractor Talk Discussion Board |
Re: re-torque head bolts?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by the tractor vet on December 05, 2006 at 08:26:09 from (75.19.124.198):
In Reply to: re-torque head bolts? posted by Josh in Pa on December 05, 2006 at 08:17:21:
Ya get the tractor UP TO operating temp and that means up to 180-200 degrees and just as fast as you can you do the retorque YOU DO NOT LET IT COOL . Now also the head bolt on the i think the right rear corner that is the bolt that oils the rocker arms this bolt DOES NOT GET TORQUED DOWN AS MUCH , now it has been a few years since i have done and oliver and i am thinking that that hollow bot only gets pulled down to like 90-95 ft. lbs. and the rest are now here i am a bit foggy but thinking 110-115 on the rest or is it 115-120 not sure here but the oil hole bolt only gets 90-95 .
Replies:
Home
| Forums
Today's Featured Article -
The Tractor Parade: Story of a Case SC - by Bernie DeLon. On a early fall morning back in 1994, I opened the newspaper and happened to spy an article about a local antique tractor club having their annual show that weekend.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|