Tractor Talk Discussion Board |
Re: got a question for you guys..
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by thejdman01 on December 03, 2006 at 16:04:13 from (205.188.117.14):
In Reply to: got a question for you guys.. posted by Tim Shultz on December 03, 2006 at 10:30:30:
As for the cardboard ? i cant remember if your model truck has a guage or an idiot light. HOpefully a guage becusae shen the light ocomes on its too late. IF it has a guage jsut start w/a decent sized cardborad and start trimmign w/your pocket knife. Keep an eye on the gauge. Keep maybe 2 or 3 peices of card board around fone for the -0 days (bigger) one for the 20's days etc. Depending on your driving etc if your thoermostats workign probperly shoulnt have a problem kepeign i twarm.
Replies:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|