Tractor Talk Discussion Board |
Pic Ia gary
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by NO tools on December 02, 2006 at 16:51:38 from (71.79.44.154):
Gary here is one of the hawgs this one is a D10N 570 horse this one has 3412 engine run 1200 rpm 2.6 2nd gear. This is one of the 70 yard blades. I don't have pic's of the 9h hawg here.notice the stake is stainless steel made in our machine shop not chrome.the heat and rain????. This ole hawg here 20-22 gallon per hour if right operator on it.not bragging i have literally pushed the gut out of it and made 25 gph this thing took 5 truck to put it on the job and 875.0000 to for them to get. it weights 147.0000 ready to work. gary have a good"n" Bill
Replies:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|