Tractor Talk Discussion Board |
Re: Why Not An IH 2+2 ?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Don-Wi on November 30, 2006 at 23:51:01 from (152.163.100.74):
In Reply to: Why Not An IH 2+2 ? posted by davpal on November 30, 2006 at 23:44:18:
I'm not an IH guy, but one of our neighbors had one, forget the model. They used to use it for everything. It pulled the chopper till they gto an older JD sp unit, and they did all of theire heavy tillage with it too. About 3-4 years ago they must've traded it off for another Case MFWD, as now they've got 2, one that has a loader frame on it but I've yet to actually see the arms mounted on it, and the other one they now use with duals on the back pulling the heavy tillage. I've heard more bad than good about those in our area, plulling themselves in half whe the center pivot pin gets worn, etc. etc..... I guess if a guy would keep up on the maint. they may not be too bad, but most would rather have a regular MFWD tractor with the same HP. Those old 2+2's sure are long, and probably a little clumsy in smaller feilds. Donovan from Wisconsin
Replies:
Home
| Forums
Today's Featured Article -
Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|