Tractor Talk Discussion Board |
Re: O/T need help
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by dr.sportster on November 30, 2006 at 14:17:42 from (67.72.98.83):
In Reply to: O/T need help posted by Rustyfarmall on November 30, 2006 at 08:24:39:
If you do something that requires an inexpensive or reasonable price piece of equipment like floor sander,stump grinder,truck and welder,landscaping equipment.masonary stone work[mixer],handyman with van,gutter service,drywall finisher[taper]with small scafold.The list is endless but you have to also be a businessman too.If you have a tractor[bob tail] there is always a shortage of drivers to pick up containers at the ports.The chassis is supplied but you must return it.Then you run another container anyhow[fuel cost might be ruining this].I dont know what state your in.This is easy for me to say since Im in NJ where there is a labor shortage and heavy industry.Dont know too much about the midwest and rest of nation economy.How bout a limo service to drive people to the airport.There must be a website for this info.?Good luck whatever you decide.
Replies:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
John Deere B 1943
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|